3-way Magnetic Tape Holder/Workstand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for masking tape and duct tape with internal magnets that will keep your tape off the floor in use.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 114
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
I had 3 requirements when designing this:
- Must be self-standing to keep the edge of the tape off the ground when using
- Need to be able to have multiple tapes stored in a row, but grab a single roll at a time
- Must be able to store flat for non-intrusive storage on a refrigerator, etc.
Which makes the 3 ways:
- Self standing on end (not necessarily using the magnet)
- Magnetically attached on end
- Magnetically attached on back
Printed mine on an Anycubic Vyper that is not particularly well tuned, so your print results may be much nicer than mine. I used PLA with a .2mm layer height and a .4mm nozzle.
The magnets I used are 20x10x5mm bar magnets. The 2 inch tape holder uses 6, and the “1 inch” uses 5. If you only need to use the holder in one of the orientations, you can omit the other magnets. You will need to add pauses to your gcode to add the magnets.
The tape cutter edge is not particularly sharp, but should be good for masking tape. You could possibly mess with first layer settings may make a sharper edge if that is needed (i.e. add intentional elephant's foot).
Also note that the dirty masking tape on one of the pictures is from before I made the tape holder (and is part of the impetus for the self-standing feature)