1 / 4
Ryobi Tape Measure Pegboard Mount (for VonHaus/Keyhole style boards) — zdjęcie 1
1 / 4

Ryobi Tape Measure Pegboard Mount (for VonHaus/Keyhole style boards)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A secure mount that solidly clips onto the existing wire belt clip on Ryobi's RTM5M for use with VonHaus pegboards

Ocena
0 / 5
Polubienia
7
Pobrania
18
Wydruki
0
Wyświetlenia
178
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

 

A quick pegboard mount for the 5m Ryobi tape measure shown in the images (model RTM5M). This model is designed for the VonHaus pegboards, which are 1.6mm thick steel with 8/4mm pegs, but I've included the Fusion 360 and step files if you'd like to adjust it to fit another board. 

It's sized a bit looser than my Parametric Bins for VonHaus Pegboard for easier mounting/removal, and locks on to the existing wire clip securely with a nice click. You can pop it back off again, but it's low profile enough that I leave it on. You can optionally heat the clip with a lighter below before installing to melt the clip into the mount for a slightly more secure fit as seen below (be careful and don't touch the clip, and don't heat for too long and melt the tape measure itself).

The one in the photos is printed using CC3D Transparent Grass Green PETG, on its side with tree supports, but I've also had great results with PLA. Total print time on my modified Ender 3 was 18 mins. I've been using a previous iteration for a few months now and it's never popped off by accident, and the pegs have proved to be very strong. 

 

Tagi