PRUSA MK4S ENCLOSURE PSU CutOut
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure for MK4s using MDF wood or Ikea Lack table and 3d printed connectors
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 575
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
You can also use 2 ikea lack table without cutting any of the 4 legs from the one set , But you will need to put 2 legs sideways in the back (Top & Buttom surface) in order to basically add length from 55cm to 60cm Like shown below.
Keep in Mind that one of the 2 sideways legs will need to be cut just so it does stick out.
Due to its reduced height its not possible to use the prusa original spool holder so to counteract that problem you may need to use this designs :
Filament Guide:
https://www.printables.com/model/547380-low-profile-filament-guide-for-ikea-lack-enclosure
Leg Mounted SpoolHolder:
https://www.printables.com/model/532057-original-prusa-spool-holder-remix
https://www.printables.com/model/796992-left-version-of-spool-holder-for-original-prusa-en
PlexiGlass Diametions:
Front Side : 2x plexiglass Panels 43.4cm X 47.5cm (WxH)
Right Side : 27,2cm X 47.3cm (WxH)
Left Side : 2x plexiglass panels 24.3cm X 47.3cm (WxH)
Back Side : 38.2cm x 47.3cm (WxH)
i am missing the dimentions for the psu plexiglass part soon to be come
*** Be advised that this dimetions may change if you don't instal the 3d printed parts correctly
Print Settings
Material: Bambulab PETG HF BLACK (2x 1kg spools)
Resolution: 0.25 mm structural / Speed
Infill: 20% honeycomb or grid
Perimeters: 2-3mm
All parts can be printed using the Mk4s bedside printed and bigger with the exception of the (Rear Top R) model that unfortunately need to be cut to fit through the slicer and later attached using superglue