Ryobi 18v Charger Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount that holds a Ryobi 18v charger that magnets to a metal surface.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 353
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I had a few Rybobi chargers that I wanted to clear off my workbench and my pegboard wall was a little full. I have the side of a full size refrigerator that was empty space, so I created a mount to magnet the chargers to the side of the fridge.
The larger mount in the image is my first pass at a design. I realized it was just wasted filament building the walls around the charger. I ended up printing with 100% infill, with PLA. It seemed sturdy enough to not snap when putting the charger in place.
I did notice that the larger 4 hour battery would make the mount slide down the fridge, so I might need a stronger magnet or at least two magnets would be fine.
The magnets (36mm x 7mm) I used were from Amazon:
https://www.amazon.com/dp/B0CC5HMKXP?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1&th=1