1 / 2
Two Wide PSA Landscape Collectible Card Carrier for Shipping — zdjęcie 1
1 / 2

Two Wide PSA Landscape Collectible Card Carrier for Shipping

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple strong carrier to protect graded collectible cards in two wide PSA slab during shipping.

Ocena
0 / 5
Polubienia
1
Pobrania
4
Wydruki
0
Wyświetlenia
47
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial

I developed a series of collectible card protectors to protect the expensive cards that I was shipping out for sports cards and other collectible cards sold on eBay and through other sites. After cutting up cardboard and wrapping the slabs with bubblewrap, cardboard, and tape, I began to look for a better solution since cutting the cardboard was tedious and pre-cut envelope stiffeners are expensive and not that sturdy..

This model fits graded collectible cards that are enclosed in the special two wide folding card PSA slabs. This would be like two PSA slabs lined up short edge. It was designed to fit naked slabs (no plastic sleeve around the PSA slab) and sleeved PSA slabs. It may be a little loose or a little tight depending on the sleeve you use and variations in the PSA slabs.

The slots in the design are to save filament and weight. The protector weighs 1.05 ounce / 29.9 grams We have found that the weight of the holder allows cards to be shipping within the standards of the shipping labels obtained through eBay. The carrier, PSA slab and a bubble wrap mailer will weigh ~3-3.2 ounces if using standard USPS or other mail services. 

Note: For more expensive cards we also user corrogated cardboard for even more protection of the valuable card. We have never had an issue with a card shipped with these protectors.

You may need to load the STL or model and adjust the length or width by a small about (0.01-0.03 inches / 0.25 - 0.55 mm). Do not adjust the height unless you are shipping a thicker slab since the bottom layer will grow too thick. You can print two to provide top and bottom coverage for high end cards.

I calculated the average cost to print the holder was $0.51 based on a PLA cost of $15 per kilo. 

I print these in PLA and have created models for Bambu and Prusa printers. I have a Bambu X1C and a Prusa XL, so minor adjustments may be needed for your printer.

Notes:

Standard two wide landscape (think two card with long edges across bottom plus gap) PSA slab measures used for the design are: 

    7.85 inches x 2.80 inches x 0.24 inches (our measurements)

    199.1 mm x 70.7 mm x 6.35 mm (our measurements)

Settings

Filament:    PLA

Layer Height:  0.2 mm

Infill:   Grid or Gyroid (but likely does not matter due to thickness of print).

You may need to adjust depending on how true your printer is due to shrinkage.

Tagi