STRONG! Filament Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Yet another filament clip, but this one uses the force!
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 158
- Wydruki
- 3
- Wyświetlenia
- 330
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Standard Digital File License
Yes I know another filament clip…
I share my design, inspired by the one provided with Sunlu spool which works fine and has been widely copied by others, but I find they usually lack some strength. I often "unclip" them when I manipulate the spools which I find really annoying.
So here is my STRONG! Filament Clip!
It is a bit thicker than others to improve the grip on the spool edge (but only 1.4g). It will perfectly clips to Bambu Lab spools as it was my first intent (which has a small ridge on the inside) but it also works very good with other brands (tested : Sunlu, eSun, Polymaker, Jayo, tecbears… ), cardboard or platic
The tab on the external side is made flat to protect your plastic bag and allow you stack several spools
There are two position for the filament, the first is strong, the other one will definitely locks the filament! But do not worry, it is still easy to remove it by pulling on it and slide it out
I have incorporate a taper on the spool interface to made it compatible with a wide range of thickness (spools from 2mm up to 4,5mm)
I advice you to use PETG (not tested in PLA), this is why there are profiles with this material only