1 / 3
18650 Lipo Battery Pack for Wowstick Screwdriver — zdjęcie 1
1 / 3

18650 Lipo Battery Pack for Wowstick Screwdriver

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replace the battery in your wowstick with an 18650 cell.

Ocena
0 / 5
Polubienia
0
Pobrania
8
Wydruki
0
Wyświetlenia
166
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

When your wowstick battery dies, replace it with a standard 18650 cell. 

Take apart your wowstick. Pop out the button and remove the tiny metal bits in the centre then slide out the guts by pulling on the collet then push the usb charger out with something long and blunt. It's relatively easy if a bit fidly. This youtube shows the trick to disassemble very clearly. Be careful to keep the chuck together as the locking bearing rollers can fall out.

Cut the casing off 17mm back from the button slot. Cut or file a notch on each side of the freshly cut end about 2.5mm wide and 6mm deep. 

The existing wire is a little short so either extend or replace with something thin - network cable works well. Leave them extra long to make assembly easier. 

Solder wires to your battery. Protip: if recycling a cell from something else leave a tiny bit of the spot welded nickel on the battery as its much easier to solder to. If you have a clean cell, get your iron as hot as it goes and try and get a blob of solder on as quickly as possible so as not to damage the cell. Be very careful not to short the battery once it has wires, these things can output some serious current. 

Reassemble your stick triming off the excess plastic. Test everything still works now. If the charger is dead, you can get replacements boards for a couple of bucks. 

Insert the shortened stick into the main body with the wire going through and make sure it seats onto the notches so it doesn't turn. Line up the wires with the groove on the inside, then insert your cell with its wire also lined up with the groove. You shouldn't have to force it, if you do then you will likely break the wire and get it stuck half way and have to cut it off and reprint (don't ask me how I know this :|)

If you managed to get this far without destroying the connectors your can connect them and you are good to go. After faffing about with connectors I just soldered directly to the charging pcb after removing the plastic connector. You want to put the cap on first, then solder the charger keeping the wires as short as possible. Add, heatshrink or conformal coating (CA glue) a short with a fully charged 18650 is not a good thing!

The pins on my board were v+ out gnd, gnd, v+ in looking from the back. Yours might be different. Label it while you have your original connectors or look for a b for battery if they broke off during dissasembly. 

The fusion file has a couple of parameters to tweak. The tolerence for the cap and the diameter of the wowstick. For the cap, the cheat method is to print with fuzzy skin and sand slightly for a tight fit.

Good luck. Might be my imagination, but I think its got more torque now.

Tagi