Battery Holder CR123A \ RCR123A \ 16340

BEFORE STARTING THE IMPLEMENTATION OF THE PROJECT, READ CAREFULLY THE ENTIRE DESCRIPTION !!!
 

Hello Everyone

I have designed battery holders for CR123A / RCR123A / 16340 batteries using ready-made contact plates, which can be purchased from the link below. The holder is available in two versions. : 
 

• Version 1 - with pin outputs on the side of the battery holder and mounting holes for M3 screws with a depth of 3mm
   
• Version 2 - with pin outputs at the bottom or center of the battery holder. For the center output, an wire holder is available and mounting holes for M3 screws with a depth of 4mm

When you complete the project, please share a photo and a comment. Thank you and have a nice day.

IMPORTANT - READ :

• Maximum Wire Diameter 1.6mm
• Solder the wires to the contact plates before inserting them into the battery holder
   
   

Dimensions of the Battery Contact Plate used for this project:

• Plate Dimensions without Pin : 10 x 9 x 0.3mm width x height x thickness
  Pin Dimensions : 2.6 x 6 x 0.3mm width x height x thickness
  
   

What Should I Buy ? :

• Battery Contact Plates - https://a.aliexpress.com/_EwU6ocu

How to Print ? :

• Material : ANY
• Layer Height : 0.2mm
• Infill : 20%
• Wall Loops : 3
• Bottom Layers : 4
• Top Layers : 4
• Support : No
• Brim : No