Sunbeam Dehydrator Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fan for a Sunbeam DT5600 Dehydrator.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 80
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Public Domain
Material - something higher temperature, I used PC. There are heating elements just below the fan.
Support material - not required.
Print time (on my prusa mini) 42 mins.
To take the fan out you need to have a triangular screw driver bit (or just the right size flat blade driver also does the trick)
The blade angles are not quite the same as the OG. I didn't want to push the print and The original wasn't exactly a piece of art.
Installation:
- Drill out the hole with a 2.3mm drill ideally (I had a 2.5mm drill and had to use thread locker)
- If you do use the larger size drill you will need to super glue it or use some bonding compound to lock it onto the shaft.
- Don't do what I did, instead, orient the motor upside down if you are glueing the fan onto the shaft else the glue or whatever will drip down into the motor and make it hard to move.