1 / 5
Ender 3 pro | Low Profile  | All In One housing | Raspberry Pi 4 + SKR 3 — zdjęcie 1
1 / 5

Ender 3 pro | Low Profile | All In One housing | Raspberry Pi 4 + SKR 3

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

All-in-one case for my Ender 3 pro with room for a Pi4 and the MCU

Ocena
0 / 5
Polubienia
5
Pobrania
12
Wydruki
0
Wyświetlenia
222
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

After a year, I finally sat down and modelled the 3rd (and, hopefully, final) version of my vision of an All-in-one electronics case that doesn't compromise on aesthetics and performance. It mounts a Pi4 on the right and an SKR 3 on the right.

The printer runs klipper with UART wiring via the GPIO pins of the Pi to the TFT port on the SKR, but holes for the ports are provided and the use of a USB cable is supported (though I prefer the more stable and elegant internal connection)

Installation is simple except to the cable terminals on the left of the SKR: The center spine of the case prevents installation of these cables (the Power in, Heat Bed and hotend) when fully installed and pushed in. To install these, you must slide the spine out and insert the cables first before installing the SKR into the drawer.

Though I would not call this case modular, modifications are possible with the provided fusion files. To fit another MCU, only the tray for the MCU and the front cover need to be modified, which will probably be not very hard for anyone with slight experience with CAD.

 

USED HARDWARE

I'm addicted to those threaded inserts and use them more than I should. 

11 x M3 threaded inserts

7 x M3 6mm screws

14 x M3 8mm (6mm would also work fine) screws

14 x M3 T-nuts

4 x M4 16mm screws to mount the electronics fan

 

PS: With the SKR 3 pay attention to the height of the stepper drivers. The original ones from Bigtreetech with the relatively small heatsinks should fit fine. But drivers with bigger heatsinks may not be able to fit inside.