Can Dispenser Adjustable XL no support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Combined original female parts into a single piece for printing on the XL, with flat connectors for no supports.
- Ocena
- 5 / 5
- Polubienia
- 623
- Pobrania
- 1363
- Wydruki
- 4
- Wyświetlenia
- 9121
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Wanted a single piece print for the can dispenser, and just placing the parts together in prusaslicer was leaving wall lines in the part where the connectors were, so reworked it in fusion to make each side be a single part with no connection artifacts.
Used taller lip female parts from Enigma's design as the starting point, but adjusted the connector hole to expect a slightly thinner connector.
To prevent needing supports for the pins on the adjustable connector, I modified it to be flat on one side. Removed material from the bottom so that it is flush with the pins on each side.
Currently only has the 86mm wide connector for 123mm cans, as that is what I needed, but could use with any of Regis's connectors, just place with rounded long edges up in slicer and then use cut tool at 1.38mm to get the correct size
Printed on Prusa XL
PETG
15% Gyroid infill