1 / 12
Phone molle case holder (Iphone 11-16 Pro Max) NO SCREWS NO SUPPORTS
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Phone molle case holder (Iphone 11-16 Pro Max) NO SCREWS NO SUPPORTS
- Ocena
- 4,667 / 5
- Polubienia
- 76
- Pobrania
- 366
- Wydruki
- 4
- Wyświetlenia
- 2474
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (14)Wydruki i komentarze (Wydruki: 4) (Komentarze: 14)Remiksy (0)Kolekcje (105)Powiązane
Phone molle case holder (Iphone 11-16 Pro max)
- no supports and no screws needed
- fit for Iphone 11-16 Pro Max or similar size phones
- cutout for buttons
Laser or normal molle versions
- Laser version has narrower molle straps and different dimensions of hinge, so you need to use correct size of pin
- 2 versions dimensions 4x5 and 5x4 molle (look on photo)
- 3 versions of hinge position (normal, 10mm or 25mm up)
Assembly
- It may seem like the hinge is stiff, but that's okay
- If the pin won't go in, clean it up a bit with sandpaper and use hammer to put it inside
- Put clips to holes
- Thread the rubber cord through the holes in the phone case.
Print settings
- 0,2 mm layer
- 8 walls
- no supports