1 / 4
Victa / Briggs & Stratton Battery to Milwaukee Tools adaptor
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use Victa / Briggs & Stratton cordless tool batteries with Milwaukee tool skins
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 500
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Cordless tool battery adapter.
Victa / Briggs & Stratton Battery to Milwaukee skin tools
Extra hardware
- 6mm male spade connector x2
- wire
- female fuse terminal x3
- M3 x10mm bolt & Hex nut x2
- 470k resistor
- spring (0.5mm, 35mm, 5mm) a retractable pen spring will probably work too
Prep spade connectors like this, flatten out the shoulders if you can
Basic assembly procedure
- remove spade terminal sheath and crimp to wires, flatten it out
- install spring and side buttons into top
- install wired spade terminals into base and thread into the top
- bring top an bottom together, pulling wires through as you go
- use nuts and bolts to bind the top and bottom together
- trim wires appropriately to allow female terminals to fit into their slots
- crimp female terminals, remembering to include the resistor into the positive terminal
- push terminals into place, I used hot glue to cover up the resistor
Reach out if you need further clarification
If you like this model, please throw me a like. Designing the models is time, filament and coffee consuming. If you want to support my work buy me a coffee (PayPal). Thanks!