1 / 2
fits Tactical WMW Rifle Wall Hook - Low — zdjęcie 1
1 / 2

fits Tactical WMW Rifle Wall Hook - Low

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Use at your own risk !

Ocena
0 / 5
Polubienia
1
Pobrania
8
Wydruki
0
Wyświetlenia
52
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This version is 3mm thinner and has a lower hook to accomodate certain rifles. Unfortunately I made this in the free version of Shapr3D so the rounded parts are not quite round. They are still filleted and chamfered and seem to work well enough.

Made to fit a certain * tactical * company's * walls * system, with random screws of your choice that fit. I like to heat the screws lightly before screwing them in, so they'll easily self-thread. Be careful not to over-heat. 
This is not made, affiliated or designed by the above mentioned company.

Use at your own risk. I have not had any problems so far. These have a 2" filleted semicircle-ish design, with all other edges chamfered.

 

I printed with Creality PETG at 85C/265C throughout 

25mm/sec .12 first layer

250-270mm/sec .2 all subsequent layers, slow for overhangs

15% infill (you can always add more if you want)

3 top shells, 3 bottom shells, 2 wall loops

print flat on side, no supports/brims etc