T480 iPhone 15 Pro speaker mod (experimental)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Decided the stock speakers were bad, so it was time to start experimenting.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 438
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is an experiment, if you do try this then it will be at your own risk.
Decided the stock speakers were bad, so I ordered some iPhone 15 Pro speakers to mod into my T480 as an experiment.
The speakers are held in with friction and glue. I added some 2mm foam tape on the back of the speaker enclosure so that the speakers have less room to move around. I used the original connector from the speaker by removing the wires (better solution would be buying a new one, which should be a jst 1.25 4 pin connector) and added new ones. (I have it wrong in the picture; left speaker should have black and red instead of white and blue).
Overal the sound is quieter then stock. As of now I don't think it improved much, but I'll have to test more to make a definitive conclusion for the sound quality (haven't tried an equalizer just yet).
Pinout speaker connector: (left - right: White - Blue - Black - Red)
(facing the backside, with left being the side where the connector originates from).
Left speaker: Black - Red
Right speaker: White - Blue
Black and White being ground.
Not all dimensions are exactly where they should be as the drawings are crudely drawn but the speakers are able to fit quite easily.
Printed with 100% infill PETG and supports for some hanging parts. Only took half an hour.