Bracelet Chain - Totally Adjustable Length & Print in Place
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A non snap design which makes for a stronger chain A multi link chain that can be used as a decorative band or bracelet
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 216
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This chain is of the muti link type made up of separate detachable links.
THE LINKS DO NOT SNAP TOGETHER
Because the links can be detached and attached by turning to 90 degrees and sliding.
The included STL file makes 20 such links using print in place which can the be detached to make shorter sections. I recommend printing two so that a chain long enough for a bracelet can be made out of the two, adjusting to length.
My original plan was to make a drive chain or crawler track but I've not got that far yet.
Centre photo shows slotted links for adjustment but all sections can be removed and these ones are normally on the inside.
***************** UPDATE ******************
There are 2x 3MF files:-
Chain Duplex v1x20 (cartesian printer) specifically for a Creality CR10S but would probably run on anything and would adapt. - < 2 hour print
Chain Duplex v3 x20 (corexy printer) specifically for a Bambu Lab P1P with much tighter tolerances.
It has a reduced pin slot clearance which tightens the joints up and suit my new printer (Bambu Lab P1P) - 40 minute print