1 / 3
15 Degree desktop speaker wedges (Adam Audio T5V) — zdjęcie 1
1 / 3

15 Degree desktop speaker wedges (Adam Audio T5V)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Tilt to point tweeters at ears. Sounds better.

Ocena
0 / 5
Polubienia
3
Pobrania
56
Wydruki
0
Wyświetlenia
454
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution

The Adam Audio T5V model is a mid-sized powered monitor. I have to set up another office and bought a newer model, D3V*, and they come with 15-degree mounts to angle the speaker up to point the tweeter at ear level. Works great, so I copied the angle for these angled stands I made. I did want to try getting rid of the 220mm tall stands I was using which makes the speakers kind of dominate the desk. This then is a 15 degree wedge mount for the T5V monitors.

Off the printer this is kind of slippery on the desk but there are a lot of adhesive rubber products that can be used. I got a roll of silicon furniture tape, it is 1mm thick and works well. TPU would work well! The holes in this design are not necessarily to save any filament but to ensure there are some areas of rigid stacked support throughout the entire model rather than allowing for any kind of infill, which could be more or less flexible depending on pattern or percentage.

*If I was buying two sets today I'd buy D3V twice. Not as good as T5V, can't match the bass, but so small and almost as good as big brother.

Tagi