Spinning Vinyl Record Beads Charms
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Prints in two pieces and snaps together! Vinyls spin! Print in different colors and swap them around!
- Ocena
- 0 / 5
- Polubienia
- 40
- Pobrania
- 84
- Wydruki
- 1
- Wyświetlenia
- 294
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
Satisfyingly snaps together. Smoothly spins! Customize your colors! Decorate your hoodie strings and have something to fidget with! Show off your love for analog music. The hole in the center is so you can push a piece of raw filament in the center for an easy third color option. No need for a multicolor printer!
Print Settings:
Recommended to print with PETG in your favorite colors. Almost any filament should work though. Use 0.2mm layer height. Print the vinyl outer piece with grooves facing up and the bead center piece with the flat surface facing down. The grooves will look great with 0.4mm and 0.6mm nozzles. Pictures shown were printed with a 0.6mm nozzle and 0.2mm layer height. No supports needed.
If you want to customize the grooves, place it upside down in your slicer, add a disc modifier to the top 0.4mm of the disc, set top layers to 0, and choose concentric infill for the sparse infill option. 50% infill looks great, but you can mess with it if you want.
Assembly:
The first time snapping the pieces together will take some effort. Place the bead flat side down on a table, then push down firmly on the outer piece and they will snap together. To remove, do the opposite.
It will take less effort the second time. Some printers and/or filaments will have slightly different tolerances. If you want to make it easier to click in, scale the x and y dimensions to 99% in your slicer with uniform scaling turned off. Make sure the Z dimension stays at 100%.
To add a color to the center, simply push a piece of filament into the hole in the center, then cut the excess flush as seen here:
