1 / 3
Self-Balancing Rolling Robot with bearings and counterweight
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small robot that stays upright when rolling.
- Ocena
- 5 / 5
- Polubienia
- 134
- Pobrania
- 340
- Wydruki
- 9
- Wyświetlenia
- 3615
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (7)Wydruki i komentarze (Wydruki: 9) (Komentarze: 10)Remiksy (1)Kolekcje (155)Powiązane
I love what @Judhini_1605028 did to create the original model. It was just too difficult to get it to roll smoothly. I added bearings and a counterweight.
I like to create 3D models that follow these criteria:
- Do not require supports – I HATE supports.
- Print quickly – optimized for 0.4mm nozzle diameter with 2 exterior wall thickness
- Are easy to access for maintenance – I like to upgrade parts, but I hate to disassemble the entire model just to change out one part.
- Are chamfered on the bottom layer – this helps those who don't have a perfectly aligned bed and may still have “elephant foot” artifacts.
- Do not waste plastic – many designers make parts that are WAY thicker than are required for structural strength. This just makes the parts bulky and take longer to print.
Notes
- NO SUPPORTS REQUIRED
- All parts print without supports.
- Tires printed with 95A Flexible TPU filament
- I recommend slowing down print speed and adding extra retraction.
- Requires 608-2RS 8x22x7mm bearings (qty 2).
- Requires nut counterweight (qty 1)
- There are 2 versions: ½ inch-13 or M12-1.75
- ½ inch-13 Amazon: https://www.amazon.com/Nuts-13-Stainless-Steel-10pcs/dp/B0BLBL8JS9
- M12-1.75 Amazon: https://www.amazon.com/Glvaner-M12-1-75mm-Thread-Stainless-Hexagon/dp/B09B6VV7WM
Building Instructions
- All parts fit together snugly without any glue or screws.