Kunlun mag release (no jam)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a horizontal pull mag release for the Worker Kunlun
- Ocena
- 4 / 5
- Polubienia
- 5
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 231
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I got annoyed with the original Kunlun mag release that as you pull the mag out it jammed up as you need to push the mag up into the magwell for the lever to release the mag.
I have made a release that pulls horizontal so no more jams on mag release.
Features
stock hardware
spring retention (no more lost springs)
low profile
Install
To install this mag release, open up the rear section of the Kunlun, remove the original mag release lever, insert the spring into the new mag catch part, it needs to go past the retention ridge to keep it in place, place the lever on the original release pivot post, place the mag catch in with the flat side down and make sure the spring sits on the rest as the spring did with the original release lever. Make sure it works ok, but hold the catch in place as it can spring out without the side being put back in place. reassemble the blaster and now you have a low profile mag release that doesn't jam up in the mag is being pulled.
This is not compatible with the supplied cosmetic mag