UpLIFT Desk Magnetic Cable Management
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple magnetic cable management solution that is specifically sized to fit the between the frame rails of the UpLIFT Desk sit/stand frames. It may fit other desks as well.
The model requires the use of two neodymium bar magnets. These are the ones I used (affiliate link): https://amzn.to/3YgSg0s as I had some spare ones laying around, but any 10mmx5mm bar magnet that is about 60-65mm long should work.
The design is meant to use two magnets with the printed model bridging the gap between the two frame rails, providing support for whatever cables you run between them. See the photo for an example. Since the magnets come in a pack of 12, I printed 6 copies of the model and placed them strategically under the desk, depending on where I had cables and devices.
Recommended printing orientation is on the model's side, as shown in the PrusaSlicer screenshot. Use a brim if you have bed adhesion issues, but my MK4S printed them fine without one.
CAUTION: these magnets are very strong! Depending on printer calibration/tolerance they may slide out of the model easily. I may update the model with end-plugs if/when I have to print more myself, but for now this works well for me.