Tavern Torch

This decorative torch looks at home in a nice friendly tavern or dangerous dungeon. Perfect for adding nice flickering flame ambiance to your DnD game or your LARP campsite. When assembled the torch has a button on the bottom of the handle that can control the button on the flame light. The sconce can be attached straight to a wall, strapped to a tree, or even joined with slat wall connector if you have slat walls, like in many game stores.

In addition to the prints below, you will need to have at least one of my Tabletop Torch Lights. Get the files for free here https://www.printables.com/model/1212804-tabletop-torch-light

Print out one each of:

Torch Handle (for 2 colors add filament swap at 61.2mm layer height, 15%infill, no supports) Torch Top (15% infill, organic supports everywhere) 

Finger (15% infill, no support)

Button (15% infill, no support)

Spring Cylinder

Print 2 of the Alignment Pins 

Assembly instruction video is here 

The torch sconce can be printed to give you a place to hang your torch. You can screw it directly to a wall, or use an M3 bolt to connect to chking's slat wall plate if you have slat walls https://www.printables.com/model/77915-slat-wall-1u-plate-a

If you are going to be enjoying your torch in an outdoor environment, you might want to bolt a torch sconce to a tree strap holder to allow you to strap it to a tree using any preferred strap or ribbon.