Music Pill - Rock until the doctor is coming...
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Music Pill is a bluetooth enabled mobile speaker which is reusing old cardboard spools (or fake spool)
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 67
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Music Pill is a bluetooth enabled mobile speaker which is reusing old Bambulab cardboard spools. If there is no more cardboard spool, there is also a “fake spool” included in the project.
Required tools:
- Soldering Ion
Required parts:
- 2x 2-wire 150-200mm (speakers)
- 1x wire black 50mm
- 1x wire red 50mm
- 1x wire red 100mm
- 1x Switch Pololu Rocker Switch: 3-Pin, SPDT, 10A
https://eckstein-shop.de/PololuRockerSwitch3A3-Pin2CSPDT2C10A - 1x Adafruit 4410
https://eckstein-shop.de/AdafruitMicro-LipoChargerforLiPolyBattwithUSBTypeCJack - 1x 2500mA Li-Ion battery with JST-PHR-2 connector 63 × 50,3 × 8,1 mm
https://eckstein-shop.de/LiPo-Akku-Lithium-Ion-Polymer-Batterie-37V-2500mAh-mit-JST-PHR-2-Stecker-LP785060 - 2x speaker 40 × 40 × 20 mm speaker (is in reality 40 × 40 × 24 mm)
https://www.roboter-bausatz.de/p/mini-lautsprecher-40mm-4-ohm-3w - 1x bluetooth amplifier XY-BT5W
https://www.roboter-bausatz.de/p/bluetooth-4.2-audio-decoder-verstaerker-modul-xy-bt5w
Step 1: Solder speakers

Step 2: Solder Adafruit 4410 and Switch

Step 3: Mount switch into backpanel - move Adafruit 4410 through the switch mount hole

Step 4: Install Adafruit 4410 by pressing the locker through the holes

Step 5: Solder power cables to XY-BT5W

Step 6: Install speakers in the top part

Step 7: Install caps

Step 8: Prepare battery by putting the battery between both battery holder parts

Step 9: Install battery into the cardboard spool (or fake-spool)

Step 10: Install top part to the card spool and put the wires through the battery holder.

Step 11: Tighten cables

Step 12: Install electronics into bottom part

Step 13: Solder seaker wires to the amplifier board

Step 14: Install the amplifier board and lock it with the locker

Step 15: Connect the battery

Step 16: Install the connector plate

Done! Lets rock!
