Hot Cylinder PRV Handle - Heatrae Sadia Megaflo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Handle clamps to the Hot Water Cylinder PRV knob to facilitate resetting of the air gap.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 38
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
I made this handle to fit to the PRV (pressure release valve) knob on our hot water cylinder. Our Heatrae Sadia Megaflo cylinder requires the air gap to be recharged every four months or so. Without this handle your fingers go cramp while waiting for the water to drain down to the prescribed level.
The PRV knob is very slightly tapered but is nominally 25mm diameter.
The photo of the printed component shows my prototype version (the final one is already in the loft). In the final version (per attached print file) I reduced the length of the two levers.
The handle requires the addition of an M4 machine screw to clamp it to the PRV knob. It threads directly into the plastic which is quite strong enough for the purpose but you could add a nut if necessary.
It was printed in basic PETG but if that one ever fails I will re-print in PETG-CF.