1 / 2
Shade shroud housing for Anders 114mm Travel Telescope — zdjęcie 1
1 / 2

Shade shroud housing for Anders 114mm Travel Telescope

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Light blocking shroud.

Ocena
5 / 5
Polubienia
5
Pobrania
29
Wydruki
1
Wyświetlenia
310
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This print is for a light blocking shroud that fits the 114mm Travel Telescope in the link below.

While possibly not necessary depending on your light pollution level I found it helpful where I live on this telescope. 

Full length model is roughly 215mm long and will fit the standard 450mm focal length configuration of the telescope. these can be stacked as well and scaled lengthwise. Its possible to scale diameter as well but test prints are recommended for fitment to original housings. Recommend measuring between front and rear housings, and scaling to fit if necessary. Matte finish material in this function will work best. I used PETG-CF for my own and that is what is in the pics. Matte black PLA should work also though will be less resilient to damage.

114mm Travel Telescope:
https://www.printables.com/model/1038495-travel-telescope-114mm-updated-version/

Hardware required:

Possibly a little electrical tape to tighten fit if needed.

Tagi