Cupra Born center console storage tray
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is in a movable storage tray for the center console of the Cupra Born.
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 245
- Wydruki
- 1
- Wyświetlenia
- 1204
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The central storage compartment is very deep and depending on what you want to store in it, it's not that practical. This storage tray adds a top layer where you can put in little parts and pieces. Still allows to put a drinking bottle in it, as well as loads of space left beneath.
I've provided a “floor mat” which can be printed in TPU. But of course any rubber mat cut to dimensions will do.
Tray can be used with or without dividers. Those clip into the tray. I've glued them in the end when I was certain they were as I needed them.
Use ASA, ABS or at least good quality PETG. PLA or regular PET won't survive hot temperatures in summer.
Update 2025-04-13: Added a deeper variant of tray, dividers and floor.
Update 2025-04-11: Increased width of tray at the front by 0.5mm because if was a bit too narrow.