38mm Corrugated Gun Belt
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A beefier adaptation of Cisco's gnarly Caterpillar Belt, by an Idaho gunslinger.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 34
- Wydruki
- 1
- Wyświetlenia
- 658
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- BSD License
Warning: The current version of this belt broke after just a day and a half of use. The limiting factor appears to be tensile strength. To address, I'm considering polycarbonate filament and/or even thicker extrusions.
Use the models that Cisco provides for his original Caterpillar Belt. Just print them at a different scale, with substantially different slicer settings, as outlined below. The result is a taller and stiffer belt which I hope will be suitable for supporting a holster. Belt height is 38mm (1½"), a sturdy size widely supported by holsters which still fits the belt loops of most pants.
Setup for Belt
This setup is suitable for nozzles from 0.35 to 0.85 mm.
- Material: PETG
- Spiral vase mode
- Solid bottom layers: 0
- External perimeter extrusion width: 0.96mm
- XY size compensation: 0.36mm (to make my wider extrusions possible)
- Layer height: 0.52mm or 80% of nozzle size, whichever is less
- Scale:
- X & Y axes: 98%
- Z axis: 38mm
Setup for Buckle
This setup is suitable for nozzles from 0.25 to 1.0 mm.
- Material: PETG
- Perimeters: 2
- Infill before perimeters
- Layer height: 0.1mm
- Combine infill every: 3 layers
- Top fill pattern: Monotonic
- Infill: 100%
- Elephant-foot compensation: 0.2mm
- Ironing: 12% flow, 0.3mm spacing
- Scale: 126%
- Rotation: 90 degrees clockwise (rear of buckle at rear of bed)
- Seam position: Rear