Dr. Gusman Logic Analyzer Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Protective housing for the logic analyzer designed by Dr. Gusman
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 253
- Wydruki
- 2
- Wyświetlenia
- 691
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
Design for the v6.0+ PCB design by Dr. Gusman
Does not support board chaining.
I would suggest printing the bottom piece with the open side up and the top piece with the open side down. If you have a textured bed, I also would suggest a 1 layer raft on the top piece to preserve the surface finish. The spacers go between the PCB and the Top cover(3 needed). I made the model to work with m3 because I don't have an m2.5 so you will need to drill out the mounting holes on the pcb a little bigger.
Requires 3 x 12mm m3 screws(10mm can work if that is all you have)
Optionally you can add a 2mm diameter acrylic rod to the LED indicator hole to make it more visible
Pin tag was printed on normal paper at 600dpi and glue in place.
4/11/2025 Updated to add a larger label with switch indication. Also added a channel for the LED indicator