1 / 6
QIDI Q1 Pro - Top-Mounted Spool Holder (No Supports) — zdjęcie 1
1 / 6

QIDI Q1 Pro - Top-Mounted Spool Holder (No Supports)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This redesign requires no supports and is sturdier. The spool is moved back, so the filament is unspooled in center.

Ocena
5 / 5
Polubienia
36
Pobrania
223
Wydruki
2
Wyświetlenia
1159
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

A clean, support-free top spool mount for the QIDI Q1 Pro, designed for smoother filament pathing and easy printing. The spool sits slightly farther back so filament feeds closer to the gantry center, and the holder is a bit taller to reduce tight bends (kinder to brittle filaments).

Features
  • No supports required for any part
  • Improved pathing: rear-shifted spool position for straighter peel-off
  • Extra height to avoid sharp radii on stiff/brittle filaments
  • Solid, wobble-resistant mount
Hardware
  • 4 × M3×8 mm screws
  • 4x M3 heat-set inserts (≈ 5 mm OD × 4 mm depth)
  • 2x 608 bearing for the spool roller
  • additional 4x M3 inserts if you want to mount anything to the optional mounting points in the center stabilizer
Print Settings
  • Material: PETG or ABS/ASA recommended (heat + toughness)
  • Layer height: 0.2 mm (or your normal profile)
  • Infill: 20–30% (grid/gyroid)
  • Walls/Perimeters: 3–4
  • Orientation: Print parts as shown in the screenshots. no supports should be needed
  • Brim/Raft: Optional if your adhesion is iffy
Assembly & Use
  • Press or set the M3 heat-set inserts into the center stabilizer.
  • Screw the stabilizer in place with M3×8 screws.
  • Mount the spool holder on top of the Q1 Pro to the existing lid riser
  • Load the spool and feed filament directly to the extruder.
  • Check that the filament path is smooth with no sharp bends.

Tagi