Infinity Calibration Cube Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds your 30mm calibration cubes in place. Grows infinitely. Partly compatible with GRIDFINITY.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 88
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Whether you calibrate your printer on each new filament or occasionally you might notice all this calibration cubes lying here and there. Be proud of yourself and demonstrate your hard calibration achievements by storing on demonstrating all your cubes using this simple yet effective infinity holder system. It grows as you need, in the direction you need (well, frankly, only 2/4).
H511 - 1x1 unit of version 5 is compatible with GRIDFINITY. H6xx - don't, but it does connect with H511. Thus if you need just place holder with a cube in GRIDFINITY - use H511 units and place as much as you need one holder per one unit. If you need to display somewhere on a wall interconnect any units and use screw cap to hold some of them.
Snaps tight. Side with “jaws” snaps on top of the other one since it has lip closer to the top and you'll have “more" easy travel until the other side will hit the lip.