1 / 1
Side brackets 12x24.5mm and 12x32mm for 3mm countersunk screws — zdjęcie 1

Side brackets 12x24.5mm and 12x32mm for 3mm countersunk screws

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The brackets were designed to secure side panels using one 3x12+mm and two 3x8+mm countersunk screws.

Ocena
0 / 5
Polubienia
2
Pobrania
15
Wydruki
0
Wyświetlenia
55
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

These are two versions of a side bracket, made to secure side panels with three 3mm countersunk screws per bracket.

The depth of the screw shaft (including countersunk screw head) on a longer side is 8mm in total and on a short side the both screw shafts/holes have a total length of 4mm (same as the basic bracket thickness). 

The proportions of the brackets are:

  • The short side size: 12mm 

  • The long side size: 24.5mm (the 1" version) or 32mm (the 1 ⅓" version)

  • Bracket width: 24mm

  • Basic bracket thickness: 4mm

  • Screw hole diameter: 3mm

 

3D printing tips for the side brackets:

The parts should rather be laid down on its largest surface with your slicing software for achieving the best results (visually) or, in some cases, should probably be laid sideways on one of its long edges if it really comes to maximum strength.

Supports are generally not necessary.

A little non-binding tip regarding filament choice for this model: one of my favorites among easy to print materials is PLA+ v2 from SUNLU. I would not compare it with anything like PA12-CF, but in my personal opinion it still shows relatively good results for parts used indoor in a low humidity environment under room temperature conditions, therefore i've used it to make some dozens of these brackets for myself.

Good luck and happy making!

gexo(-graphix), April 2025

 

This project was made using FreeCAD and other Free Open Source Software on a GNU/Linux system. My appreciation to all, who volunteer and spend their time working on free software and open hardware for the humanity.

Tagi