UniFi G5 Dome Ultra Desk/Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use your G5 Dome Ultra without drilling holes.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 123
- Wydruki
- 1
- Wyświetlenia
- 600
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
An idiot (me) ordered these cameras expecting the cable to pop out of the side - aka, I could sit them on surface - NOPE. The only way to use these cameras is to drill a hole in a surface, then screw the camera to said surface.
… not anymore.
Press fit the G5 Dome Ultra into this stand, then sit it on your desk. Or use some double-sided nano-tape and stick it to your wall.
It's a bit of a squeeze to get it in (deliberate), but at least you know it's not going anywhere.
Should go without saying, make sure that you orient the model flat against your print-bed - however no supports required.
The little “tab” poking out is there to stop the camera from tipping over.