1 / 8
Catan Number Token Box - Print-in-Place - No Supports - 7 Capacities — zdjęcie 1
1 / 8

Catan Number Token Box - Print-in-Place - No Supports - 7 Capacities

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These are lightweight, print-in-place, storage boxes for Settlers / Seafarers of Catan number tokens/markers in 7 sizes.

Ocena
5 / 5
Polubienia
45
Pobrania
246
Wydruki
5
Wyświetlenia
707
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Board Games
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

UPDATE 2026-08-12:     Fixed missing divot for the latch on the 61 mm capacity box.

UPDATE 2026-01-04:     I added a 44mm capacity box. Apparently, the French version of Catan has number tokens that are a bit thicker.

UDATE 2025-11-23:     In response to a request, I created an additional size with 25mm capacity, which holds a few more tokens than the 61mm model.

UPDATE 2025-05-18:     In response to a request, I created an additional size with 66mm capacity, which holds a few more tokens than the 61mm model. I have updated the following information to reflect this addition.

-----

These are holders for Settlers/Seafarers of Catan number tokens. They come in seven sizes or capacities (the quantity of tokens that each will hold depends on the thickness of your number tokens – over the years the thickness has varied). They are print-in-place and require virtually no post processing (other than working the hinge a few times). They are lightweight, but sturdy. 

The capacities/sizes (referring to the height of a stack of tokens) are: 66mm, 61mm, 44mm, 42mm, 38mm, 25mm & 16mm (which is a small holder for older, thin seafarers expansion tokens, to keep them separate). Measure your stack of tokens to determine the best size match.

The models are laid out in the proper printing orientation. I suggest printing with 100% infill.

After printing, the hinge may be a little stiff, or partially stuck together. Simple hold the model in an upright orientation bend down the pieces on the side while pushing up on the hinge in the middle, and this will break free the mechanism. Open and close the lid a few times and it should function well.

I have two similar designs on Printables, the original (the heaviest/uses the most filament):

and the next version, which is streamlined design to reduce weight and address a few other issues from the original:

This design is a hybrid of those two designs, and uses ~31% less filament than the original design, and 18% less filament than the streamlined version, while incorporating positive features of both previous models.

I think I have finally reached a final design. :D

Tagi