Silicabox / Silica container for the new Sunlu refill spools
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made a container for the new model spools from Sunlu, the refill spools.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 302
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My old silica containers for the Sunlu filamentspools didn't fit anymore because Sunlu now uses different refillable spools (the perforated ones, see picture). The inside diameter now is much smaller (62.7 mm vs ~72.8mm) so I had to replace the containers.
While at it I thought of a way to lock the containers inside the spool because the container sometimes shifted to the left or right while rotating.
My solution is to make a small edge on the bottom of the container, the bottom is about 70mm, so that side sits secured in the spool. For the lid I made to little holes on top for 3mm allenscrews. In these holes you have to screw the securing lips with 3mm screws with the length of 5mm or even 6mm. I used 5mm and the screws lies flush with the underside of the lid.
I only perforated the top and bottom of the container, because I think it has not much sense to perforate the side because it is fully enclosed inside the spool and it will greatly increase the print time.
I printed this in PETG for use in the new Bambu Lab AMS 2 pro which is capable of drying the filament (about 65 degrees Celsius)