Laser cut LCD montior stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small stand for an LCD monitor, with space underneath for storage.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 404
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
A laser cut monitor stand to hold up an LCD monitor and allow for access under it for storage, and a cutout in the rear for cables to be fed under it.
Dimensions:
9 in deep
5 in tall
13.5 in wide
Not sure of exact weight limit but holding my 19in LCD monitor with no issues.
Created in Fusion 360 during a boring Zoom meeting in less than 10 minutes.
Cut out of 5MM Plywood using an M360 60 water UV laser.
All joints were resized so that they will fit tightly, this was done taking .1mm from each fingers in each join, which accounts for the kerf on most laser cutters (about .2mm)
its possible they might break if you assemble it without glue and then disassemble it to glue them together.
After cutting clean the surfaces to remove any soot or building from the cutting, remove any extra material not removed by the cutter. Apply glue to one side of each finger that mates with other parts and assemble. Putting a 5lb weight on top of it during the drying process will ensure it does not warp.
Do not apply heavy weight until glue is dried.
After dried paint and allow paint to dry.