1 / 3
Lamy Safari Cap Screw Replacement
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement for the plastic screw holding the cap, clip, and liner together on a Lamy Safari fountain pen
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 94
- Wydruki
- 0
- Wyświetlenia
- 553
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
The Lamy Safari's cap is held together by a plastic screw going into a brass bushing. The screw is fragile and can snap if too much stress is put on the clip.
This is a replacement for that screw. The thread in the bushing is M5, which is hard to print, so the replacement is unthreaded and taps into the bushing.
Print settings:
- Default STL has a 4.46mm screw shank. Adjust thread_dia in the included OpenSCAD and use trial and error til it fits
- ASA or any other filament with good inter-layer bonding like PA
- 0.4mm nozzle
- 0.1mm layer height
- 100% infill or 3 walls and default infill%
- As slow and hot as possible for good layer bonding without blobs
- may need to print one at a time if there is stringing or poor adhesion
Assembly:
Before putting the cap back together, form a thread in the screw using the bushing by hand. Once the screw fits the bushing by hand, reassemble the barrel.