RAK19007 Meshtastic Mounting box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For mounting a Meshtastic node based around the RAK19007 board with the RAK4631 radio
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 446
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
So this is a box i made to mount my Metastatic node…
The 3D printed parts form the Base and Lid that should be printed in a suitable weather resistant material, I used PETG but ASA would probably be best and a Gasket that should be printed in TPU or TPE
you will also need:
4x M4x25mm machine screws and nuts
4x M3x10mm machine screws and nuts
4x self tapping screws I used M2.6x6mm
A 20mm Stuffing Gland for cable entry or a water resistant USB C passthrough
https://www.amazon.co.uk/dp/B0DM5Z7LWP or Similar
(you can make the hole smaller if you want to use a 16mm)
A SMA-Ntype bulkhead connector
https://www.ebay.co.uk/itm/153363139796 or similar - Adjust the holes if you need
Obviously the Node, small Lipo Battery and associated UFL to SMA-M cable
Silica Gel pouches recommended (the ones you get free with filament are absolutely fine)
Please note this is Licenced CC-BY-NC-SA… You are welcome to print them for your own use, print them and give away to other people in your local mesh or whatever…
If you want to Print these to sell for a profit or use to make prebuilt nodes that you sell then please contact me for Commerical licencing arrangements