QIDI Plus4 Slim Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Low profile handle for the QIDI Plus4 glass door.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 129
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I store my printer in a cabinet and due to bad measurement on my part, I can't close the cabinet door properly if I wanted to also have a poop chute and not choke my rear fan. Designed this handle to allow me to place the printer as close to the front edge of the cabinet as possible while still allowing me to close the door fully and still have some space behind the printer. First world problems, but here we are.
There are three files for you to pick from.
QIDI Plus4 Slim Handle - No Hole: technically has a hole to indicate the location of the screws. For you to tweak/mod as you see fit.
QIDI Plus4 Slim Handle - 3mm Hole: you can use the stock screws to tap through.
QIDI Plus4 Slim Handle - 3mm Square Nut: if you feel safer to bolt on with a nut, use this model.
No supports needed for the print and up to you on the infills and walls.
The attached picture is the 3mm Square Nut version printed in PETG with 25% gyroid infill. Don't look that great 'cos I was just testing it out but will reprint it later.