1 / 10
10" Homelab Rack Ubiquiti PoE 16 Lite — zdjęcie 1
1 / 10

10" Homelab Rack Ubiquiti PoE 16 Lite

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

10" Homelab Rack Ubiquiti PoE 16 Lite to house the unit in a rack

Ocena
0 / 5
Polubienia
9
Pobrania
59
Wydruki
0
Wyświetlenia
426
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Designed to suit my own needs alongside other models I've uploaded on Printables

** NOTE: These Rack components were designed to fit a HOME MADE rack using rack rails and my supports to build a home made rack, therefore they may not fit your own store bought rack if you went down that path without a little modification - please check before printing.  The designs are 250mm wide with a space between the upright rails being 220mm.  Although some models within the range are slightly less than the 220mm.  Please check before printing.

The Ubiquiti PoE 16 Lite is actually larger than 1U so consider this if you are planning on installing one.  I installed this module first then devices above/below to allow slotting in.

3 Different Prints:

  1. Front panel

  2. Sides (There are two :-)) - with an F on the front as they are slightly different measurements.

  3. Rear panel with Unifi Logo and Power Cut Out

You'll need threaded inserts to take full advantage of the build:

  • The 1U Blade uses 8x M3 Inserts

 

I've printed all mine in PETG (Galaxy Black) with 15% infil, no brim on the 1U Blade and organic supports on models that need it.

Tagi