GMKtech Nucbox M3 Wall Holder + Charger Brick
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Why is the power brick bigger than the mini pc itself?
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 220
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Not so small mount for the GMKtech nucbox m3 to mount it to the wall and its bigass power brick.
Notes-
The case is intended for #4 screws with 40 pound wall anchors. The lid is intended to use m4 sized machine screws up to 17mm in length.
The way the wires travel can be changed by mirroring the case in the Y direction (defaults to the right side)
Print the case upright, with a brim if not in petg and enclosure.
The power brick wire goes in the front with the fixed wire being on the top.
There is 2 points near the end of the case to use smallish zip ties to hold the wires if required.
Changing the fan curve for the fan to start at 50C is recommended to lower the noise from the default 35C.