CREALITY K1max - CFS SYSTEM MOUNT V1.2

*If you have any issues with printing or assembly, feel free to message me, and I'll do my best to assist you 😉.

CFS Mount for the Riser V3 - This is a custom MOUNT to install the CFS unit on top of the RISER V3.

/////ATTENTION - V1.2 UPDATE

I reviewed the project, made a few changes, and found the main issue with the original part.

As the part cools down, it shrinks slightly, and that causes the wall between the left and right sides to end up at a slight angle instead of a perfect 90 degrees. When you join the two halves, even without any weight, the centre sags a little. 

The 2 degrees tilt is enough to make a difference.

I fixed this by adjusting the design to include that angle, so when you place the CFS on top, it stays nice and level. 

*I recommend at least 30% infill.

/////For anyone who already printed V1, I made a small spacer that straightens everything out in the end. You only need the spacer for the joints that hang. The ones sitting on the riser don’t need anything.  

*PRINT VERTICALLY - SPACER_V1.stl

*If you already have the Riser V3 (Slider version) installed, you only need to replace the rear left corner piece with the updated one that includes a hole for the PTFE tube.

/////ATTENTION - PDF GUIDE AVAILABLE  AT THE BOTTOM OF THE FILES SECTION

______________________________________________________________________________________________________________

/////LINKS FOR THE HARDWARE USED IN ALL MY PROJECTS * affiliate links

INSERTS M3 x 4mm (L) x 5mm (D): https://amzn.to/3EovAVw

HEX SOCKET CAP M3 6mm-30mm (STAINLESS): https://amzn.to/4imGAQW

HEX SOCKET CAP M3 6-20mm (BLACK): https://amzn.to/3R7wjx4

FLAT HEAD SOCKET CAP M3 4mm-12mm (STAINLESS): https://amzn.to/3G3Z1wr

FLAT HEAD SOCKET CAP M3 8mm-25mm (BLACK): https://amzn.to/43JeThP

________________________________________________________________________________________________________________

Make sure the bolts aren't too long. They shouldn't go past the frame's thickness to avoid damaging any internal components.

/////CFS MOUNT FOR THE RISER V3

This is a custom MOUNT to install the CFS unit on top of the RISER V3.

There are two versions available:

1. FRONTSLIDER – The glass slides out through the front.
2. BACKSLIDER – The glass slides out through the back.

In the FRONTSLIDER version, the MOUNT has side and back flanges to keep it fixed in place.

In the BACKSLIDER version, there’s an opening at the back of the MOUNT that allows the glass to slide out of the printer. The opening is limited, it only goes as far as the MOUNT allows.

It’s also possible to use both openings on the riser frame, allowing the glass to slide either forward or backward.