Drill & Endmill Containers (fully parametric .f3d)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy to use protective container for endmills & drills, featuring ribs for secure cap holding and minimal filament use.
- Ocena
- 4 / 5
- Polubienia
- 35
- Pobrania
- 117
- Wydruki
- 0
- Wyświetlenia
- 521
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This is an easy to use protective container for endmills and drills, featuring ribs for secure cap holding and minimal filament usage. I've included the fully parametric Fusion 360 file, allowing you to easily adjust it to meet your specific needs for various sizes of tools. Optimized for printing in sequential vase mode with a 0.4mm nozzle and 0.6mm wall thickness—ideal for this use case. I recommend using translucent clear PETG filament for printing to achieve some transparency, if desired. Also for faster printing, I highly recommend adjusting the "min print speed" in the filament part cooling settings to 40 mm/s. This change can reduce the total print time to just 30 minutes, compared to nearly 2 hours with the standard settings.
Disclaimer :
I have not set specific limits or minimum values on the variables in the parameter list. The model may fail to reconstruct correctly if non valid values are given as input and I recommend restarting from the initial file.
Sizes :
I have created a range of container sizes including 4 / 6 / 8 / 10mm diameter endmills and drills, available in STL format. For the 8mm and 10mm endmill containers, both long and short versions are included.
How to use:
- You need to have Fusion 360 already installed.
- Open Fusion 360 & upload or open .f3d file. Under “MODIFY” menu choose “Change Parameters” as shown below.
- Right click on each color marked component and click “Save As Mesh”.
- Export, print and enjoy!
