1 / 5
FPV ESC SOLDERING HELPING HAND (30x30)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick print for helping when soldering onto an ESC. I used it for a 30x30 ESC. You can use M3 screws to hold the esc.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 199
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
- This is a tool I built as I was struggling to hold in place my ESC when soldering on my drone.
It's anything but fancy…but it works.
It provides you a stable platform to stick the ESC on (I screwed it to a piece of timber I use when holding some of my parts.
- The holes are 30mmx30mm (5 inch drones have these ESC)
- M3 screws will fit
- I used some spare washers from the ESC I received to lock them in
- Printed in PLA
- You can't screw the part to a piece of timber…I have a jig I use when soldering to hold parts up
The whole purpose of this part is to make it stable and hold the esc in place when pre-soldering some of the cable onto it (e.g. buzzer or LEDs) when you don't need the ESC to be on the drone.