Gabb Watch 3/3e Charger Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A handy stand for your Gabb Watch 3 or 3E wireless charger.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 41
- Wydruki
- 2
- Wyświetlenia
- 158
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Design
This is a handy charger that you can mount on your wall or sit on your desk. It is built with both the stock and sport bands in mind. I used some peel-and-stick velcro to secure it on both the wall and the stand.
Printing
When I printed this, I printed them on the upward-facing part, as I showed in the photo. I also enabled support everywhere. In hindsight, I would've put them on the build plate to give it a more finished look.
Assembly
You slip the charger in the back for the assembly, routing the cord through the slot. Then, you place the plate onto the back to cover up the rear of the charger. It can be held in by friction and easily taken out for travel.
Disclaimer
I want to be honest: I only printed the right wall-mounted and double tabletop charger. Because I did not need these other chargers, I decided not to print them. The single table top charger is just the double cut in half, and the left wall mounted is a mirror of the right. If you have success with these prints, please post photos in the make section!
This is my first Printables model, so I would appreciate your feedback!