1 / 3
PTFE Passthrough for Original Prusa Enclosure MMU3 XL — zdjęcie 1
1 / 3

PTFE Passthrough for Original Prusa Enclosure MMU3 XL

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cutout for the rear panel of the Original Prusa Enclosure to passthrough the MMU3 PTFE tubes without any sharp bends.

Ocena
5 / 5
Polubienia
21
Pobrania
55
Wydruki
3
Wyświetlenia
510
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I remade the orginal model to be able to pass the Magnetic Quick Disconnect for MMU PTFE Tubes PC4-M10 version through the hole in the enclosure panel to easily detach the (Un)original Prusa Drybox from the enclosure.

The spacing between the PTFE tube holes is 14mm as it is for the quick connect and the MMU3 so that you do not have additional bends inside the enclosure.

Changelog:

  • 2025-08-31: Uploaded the MillingGuideRing which I apparently forgot to do …
  • 2025-04-12: Uploaded first public R3 revision of this model.

Additional Hardware you need:

  • 6 x M3 nuts
  • 6 x M3x8 socket head cap screws
  • If you want to use the MillingGuide

Printing

  • Material: PETG, I also used PETG for the plug, that's a good enough “seal”, the enclosure isn't airtight anyway.
  • Nozzle: 0.4mm
  • Layer Height: 0.2mm
  • Perimeters: 2
  • Infill: 15% Gyroid
  • Supports: Only the InnerRing needs supports in the screw holes

Installation

  • The Plug has 4.2mm diameter holes for the PTFE tubes however I suggest to use a 4mm drill to “ream” them to remove any obstructions caused by seams. Just use the drill bit by hand to clean the holes.

 

  • Use the OuterRing to mark the position where you want to install that passthrough.
  • Also mark the screw hole positions.
  • Drill the screw holes using a 3mm drill.
  • Attach the MillingGuide using the same screw holes together with the MillingGuideRing.
  • Use my Milling guide for Proxxon IBS-E to cutout the hole in the rear panel.
  • Cut the upper and lower slots almost completely and leave the retaining bridges until the very end.

 

  • Is used the OuterRing as a backing plate for milling but afterwards realized that my end mill cut into it and a special backing plate for milling is required. That's why I added the MillingGuideRing.

Tagi