Carvera Laser on a Shaft
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Relocate to the Carvera laser to a shaft, just like the Carvera Air!
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 262
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
It can be useful to minimize collisions on the 4th axis to remove the laser from the spindle head, and instead only attach it when required.
This adapter plate is secured using the screws on the top of the original Carvera laser to allow you to thread on a shaft from the Carvera wireless probe. Now you can use the Carvera Laser just like the Carvera Air, whenever you need it without it getting in the way
Use a 3 pin M to F JST connector extension such as https://www.aliexpress.com/item/1005007088831721.html to extend the wires
The centre bore needs to be thread for M5x0.5mm. This can be achieved with a M3 threadmill and careful trial and error (I found 0.15mm offset to be sufficient).
Change the machine configuration to let the machine know that the laser is now not offset in x and y, and now offset 80mm in Z with the following mdi commands:
config-set sd laser_module_offset_z -90.0
config-set sd laser_module_offset_y 0
config-set sd laser_module_offset_x 0