1 / 3
Bike chain wear gauge - chain checker — zdjęcie 1
1 / 3

Bike chain wear gauge - chain checker

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3D printable chain wear gauge with built-in calibration for accurate bike chain maintenance

Ocena
4,2 / 5
Polubienia
41
Pobrania
377
Wydruki
6
Wyświetlenia
2154
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Share Alike

This chain wear gauge is optimized for FDM 3D printing and includes built-in calibration features to ensure accurate measurements. It's based on the Shimano TL-CN42 and other 3-pin gauges that measure pin wear, not roller wear—an important distinction, as roller wear doesn’t contribute to actual chain “stretch.” 

You can learn more about this here:

http://pardo.net/bike/pic/fail-004/000.html

 

Calibration

To ensure your print is accurate, the gauge includes a built-in 100mm calibration bar. Measure it with digital calipers after printing:

  • ✅ If it measures within ±0.1 mm, you’re good to go.

     
  • ❌ If it’s outside that range, you’ll need to scale the model in your slicer and reprint. Just a 0.1 mm error here can cause a 0.1% reading error in chain wear.

     

Need to reprint? No problem.
Print accuracy can vary due to your printer, slicer settings, or even thermal shrinkage. You can fix this easily by adjusting the scale of the model. Here's a simple formula you can use:


If you want even more precision, you can try again using this equation:


 

Using the Gauge

  1. Insert the left end of the gauge into the chain—this side will snap into place and apply slight tension.

     
  2. Swing the right side down and check if it fits between the rollers.

    • If it fits: The chain has at least that much wear (e.g., 0.5%).

       
    • If it doesn’t: Move down to the next smallest marking.

Continue until you find the percentage that fits without forcing it—that’s your current chain wear.

(in this picture, it doesn't fit between the rollers, so my chain is still good to go.)

When to replace the chain?

Generally, it is recommended replace the chain according to this table:

Drivetrain typeWhen to replace
10-11 speed0.5% wear
6-9 speed0.75% wear
Single speed1.00% wear


 It’s too long to fit on my printer bed

The full-size version spans 8 inches of chain, which gives more accurate results due to its longer span. But… since not all printers can accommodate this, I have created a 6 inch version. 

Note, this has less margin for error on the dimensional accuracy of the printed part, so be sure to get it as close to 100mm as possible during calibration.

 

Want to remix the design?

The Onshape CAD can be found here

Tagi