S.I.M.P. the Stringer Internal Magazine Pistol (Nerf Blaster)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
S.I.M.P. is a fully 3d printable Half Dart stringer pistol with an internal mag
- Ocena
- 4,667 / 5
- Polubienia
- 284
- Pobrania
- 1213
- Wydruki
- 7
- Wyświetlenia
- 10 227
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
S.I.M.P. is a fully 3d printable Half Dart stringer pistol with an internal magazine that requires no extra hardware other than the elastic string. This Blasters fps will depend on the elastic put in it but it should have the fps as a typical half dart stringer. (Approximately 70 fps).
Use 18 in of elastic.
The Slide and Muzzle STL's have two different variants, one version for an iron sight setup, and one version for a picatinny rail setup. Pair the two together when printing.
The Spring STL is NOT MINE, original file comes from here: https://www.printables.com/model/539241-bottom-and-spring-for-suret-mag-nerf-half-darttalo/files
Printing WILL likely require supports (Especially on the main body) The print settings I used were 5 walls and 10% gyroid infill and tree supports but this probably should change depending on your setup.
This was made by me, DuBois, callsign DB.
Questions or suggestions? Email me at: [email protected]
If you like my designs, and want to support any future designs, consider buying me a coffee at https://buymeacoffee.com/dubois
All donations go directly into a savings account for my future mechanical engineering degree!
Subscribe to me on Youtube at @DubiousBwah