Fanmade Apex Legends Coin (non-MMU)

This is a fan-made project based on Apex Legends. Apex Legends and all related marks and imagery are the property of Electronic Arts Inc. This project is not affiliated with or endorsed by Electronic Arts or Respawn Entertainment.

I've split the coin separating the outer 2mm ring of the coin from the inner portion so that I could print the inner twice, glue them together and then glue the ring to that and have a full coin that doesn't have the layer color transitions apparent on the outside. 

For Apex Coin Inner

• Sliced on Orca using 0.4mm Nozzle with a layer height of 0.08mm and first layer height of 0.2mm
• Start with Red
• Pause at Layer 18 and switch to Black
• Pause at Layer 21 and switch to Gold
• (Optional, if you don't have lots of Gold and want to conserve, you can switch instead to White here and then add a Pause at Layer 25 to switch to Gold.  This will give you the AC and inner lines as white but keep the top outermost ring gold to match the wrapping ring print.)

For Apex Coin Ring

• Load into Orca and then scale the file in the X/Y axis from 50.00mm to 50.10mm.  This is the scaling used for my printer with my tolerances.  Your printer might be better or worse, just make sure to scale X/Y identically.
• Then Scale the Z axis to 4.6mm.  This is done to make the ring match the width and just a little bit more after you glue the 2 halves together.  I did not round the bottom of the ring so depending on your printer you may get a bit of elephant footing but I didn't find it to be too big of an issue.  You could take the ring and flip it on itself to get the rounding on both sides but you'll still want to make sure you make it an overall Z height of 4.6 or close too it otherwise you may not hide all of the color changes on the Inner coins.