1 / 3
Fog Lamp Mount for Toyota Sera (EXY10) — zdjęcie 1
1 / 3

Fog Lamp Mount for Toyota Sera (EXY10)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A custom-made fog lamp mount for the Toyota Sera.

Ocena
0 / 5
Polubienia
0
Pobrania
23
Wydruki
0
Wyświetlenia
238
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial

This is a custom-made bracket for attaching fog lamps to a Toyota Sera that did not come with a factory fog lamp.

Bill-of-Materials

  • x2 M8 x 1.0 self-locking nut - Amazon (affiliate link)
  • x2 M8 x 1.0 D 10mm bolt - Amazon (affiliate link)
  • Fog Lamp Kit - Amazon (affiliate link)
  • (optional) OEM Style Fog Lamp Switch - Amazon (affiliate link)

Print Instructions

  • USING ASA FILAMENT IS STRONGLY RECOMMENDED. It will provide the best rigidity, UV, and temperature resistant as this part is used on the outside of the car.
  • Print with your best settings for ASA.
  • Walls: 6 walls
  • Infill: 100% infill

Instructions to install

Follow these instructions at your own risk.

  1. Assemble the fog lamps, and attach to the printed bracket.
  2. Remove the under cover below the turn signal lamp. (There are two Phillips head screws.)
  3. Move aside the under cover. Unscrew the turn signal lamp housing from the fender, and remove the turn signal lamp housing.
  4. Insert an M8 nut into the printed bracket.
  5. Place the printed bracket and align it to the hole visible from behind the tow hook weld point where the turn signal bracket was removed.
  6. Thread in the M8 bolt, then tightened to desired torque and position.
  7. Repeat for the other side.

No warranty expressed or implied.

Tagi